How to Reset Toner Counter on Brother HL-L2300D

Override the false "Toner Low" or "Replace Toner" error lights and use 100% of your print cartridge lifespan with this manual reset sequence.

Difficulty Easy

Time Needed ~2 Minutes

Compatible With HL-L2300D

Tools Required None (Manual)

Important Safety & Care Note: Ensure the printer is powered down before initiating the procedure. Handle the front access door carefully—do not slam or force sensor components while performing the timing combination.

Control Panel Light Reference

Toner Light Paper Light Drum Light Ready Light (Green)

Reset Sequence Instructions

0 of 7 completed

Step 1 Power Off

Turn Off the Printer

Press and hold the Power Button on the side panel until all LED lights go dark and the machine completely powers off.

Step 2 Front Cover

Open Front Toner Door

Pull down the front cover of the printer (the door used to access the toner cartridge). Leave this door open for the upcoming steps.

Step 3 Button Combo

Initiate Reset Mode

Press and hold the Go Button. While keeping the Go button pressed down, press the Power Button once to switch the printer back on.

Step 4 LED Check

Wait for Lights & Release Go

Keep holding the Go button until the Toner, Paper, and Drum LEDs are illuminated solid simultaneously. Once lit, release the Go Button.

Step 5 Press 9 Times

Clear Initial Counter

Press the Go Button 9 times in rapid succession. All lights will momentarily switch off and then light back up solid.

Step 6 Press 5 Times

Set Standard Toner Value

Press the Go Button 5 times in rapid succession.

Step 7 Finish

Close Cover & Verify

Close the front toner door. The printer will cycle through a brief warm-up process. The Ready Light will turn solid green, confirming a successful reset!

Quick Cheat Sheet

Brother HL-L2300D Toner Reset Instructions:
1. Turn printer OFF.
2. Open front toner door.
3. Hold GO button & press POWER button.
4. Release GO when Toner/Paper/Drum lights illuminate solid.
5. Press GO 9 times (lights will turn off and back on).
6. Press GO 5 times.
7. Close front door (Printer warms up & resets counter).

Reset Didn't Work?

If the toner light remains on after completion, turn the printer off and repeat the steps, ensuring you press the Go button deliberately without pauses during the 9-press and 5-press sequences.

Brother HL-L2300D Toner Reset Guide • Embeddable Article Component

Brother HL-L2300D Toner Reset Guide (Step-by-Step)